fence_xcat

Langue: en

Autres versions - même langue

Version: 364354 (ubuntu - 25/10/10)

Section: 8 (Commandes administrateur)

Sommaire

NAME

fence_xcat - I/O Fencing agent for xcat environments

SYNOPSIS

fence_xcat [OPTION]...

DESCRIPTION

fence_xcat is a wrapper to the rpower(1) command that is distributed with the xCAT project available at http://www.xcat.org. Use of fence_xcat requires that xcat has already been properly configured for your environment. Refer to xCAT(1) for more information on configuring xCAT.

fence_xcat accepts options on the command line as well as from stdin. fenced sends parameters through stdin when it execs the agent. fence_xcat can be run by itself with command line options which is useful for testing.

NOTE: It is recommended that fence_bladecenter(8) is used instead of fence_xcat if the bladecenter firmware supports telnet. This interface is much cleaner and easier to setup.

Vendor URL: http://www.xcat.org

OPTIONS

-h
Print out a help message describing available options, then exit.
-n nodename
The nodename as defined in nodelist.tab of the xCAT setup.
-o action
The action required. on, off, reset (default) or stat.
-r rpower
The path to the rpower binary.
-q
Quiet mode: print only error messages.
-V
Print out a version message, then exit.

STDIN PARAMETERS

agent = < param >
This option is used by fence_node(8) and is ignored by fence_xcat.
nodename = < param >
The nodename as defined in nodelist.tab of the xCAT setup.
action = < param >
The action required. on, off, reset (default) or stat.
rpower = < param >
The path to the rpower binary.

SEE ALSO

fence(8), fence_node(8), fence_bladecenter(8), nodelist.tab(8), rpower(1), xCAT(1)