Langue: en

Version: 300718 (debian - 07/07/09)

Section: 4 (Pilotes et protocoles réseau)

BSD mandoc


asr - driver for Adaptec I2O based SCSI/ATA host bus adapters


device asr


The Adaptec driver provides access to disks and disk arrays controlled by I2O based host bus adapters and SmartRAID SCSI RAID adapters through the standard SCSI disk da(4) interface.

The supported adapters provide 64 bit PCI, Compact PCI, Zero Channel PCI, and up to four channels of Ultra2, Ultra 160, or Ultra320 SCSI, or two channels of 1GB Fibre. All support RAID-0, RAID-1, RAID-10, RAID-5 and RAID-50 arrays. All SCSI target types are supported. For the ATA based controllers, one IDE drive per channel is supported. Hot-swapping of IDE drives is not supported at this time.

All host bus adapters must be configured before they can be used with any operating system. Please contact Adaptec directly to obtain the latest information on configuration utilities for the adapters. Currently there are both a Motif based GUI configuration utility and a CLI based configuration utility available from the Adaptec Web site. The cards and arrays can also be configured via the BIOS based configuration tool (SMOR).


The adapters currently supported by the driver include the following:


Adaptec SCSI RAID control nodes


The ATA based controllers present their devices as SCSI-like devices via CAM. For IDE drives attached to these cards, a subset of standard SCSI commands and mode pages are understood via translation performed in the card's firmware.




The (Adaptec SCSI RAID) driver first appeared as the dpti2o driver under BSDi Bs x 3.2 , then under Fx 2.2.8 and was ported over to the CAM layer represented in 4.0.


An -nosplit The driver was kindly donated by Adaptec and is maintained by An Mark Salyzyn Aq . This manual page was written by An Mark Salyzyn and fixed up by An Jeroen Ruigrok van der Werven Aq .