Langue: en

Version: 300752 (debian - 07/07/09)

Section: 4 (Pilotes et protocoles réseau)

BSD mandoc


ctau - driver for synchronous Cronyx Tau WAN adapters


device ctau

Additional options: device sppp options NETGRAPH options NETGRAPH_CRONYX

In /boot/device.hints hint.ctau.0.at=isa hint.ctau.0.port=0x240 hint.ctau.0.irq=15 hint.ctau.0.drq=7


The driver needs either sppp(4) or netgraph(4). Which one to use is determined by the NETGRAPH_CRONYX option. If this option is present in your kernel configuration file, the driver will be compiled with netgraph(4) support. Otherwise, it will be compiled with sppp(4) support.

The base I/O port address specified in /boot/device.hints must match the port address set by the jumpers on the board. The DMA I/O channel and interrupt request numbers are configured by software at adapter initialization. Legal values are:

0x200, 0x220, 0x240, 0x260, 0x280, 0x2a0, 0x2c0, 0x2e0, 0x300, 0x320, 0x340, 0x360, 0x380, 0x3a0, 0x3c0, 0x3e0
3, 5, 7, 10, 11, 12, 15
5, 6, 7

The driver supports autodetection. As for all non-PNP hardware, using autodetection could lead to some potential problems with other devices during the hardware detection process. It is always better to specify hardware resources manually.

Refer to sconfig(8) for information about the adapter configuration.


The driver supports the following cards:


cp(4), cx(4), sppp(4), ifconfig(8), sconfig(8), spppcontrol(8)


The driver was added in Fx 5.3 and Fx 4.10 . The driver for previous versions of Fx is available from http://www.cronyx.ru/