atlantic-setup

Langue: en

Version: March 8, 2001 (ubuntu - 08/07/09)

Section: 8 (Commandes administrateur)

NAME

atlantic-setup - Setup program for ethernet cards based on AT/LANTIC DP83905 chips.

SYNOPSIS

atlantic-setup [options]

DESCRIPTION

atlantic-setup is a setup and diagnostic program for ISA NE2000 Ethernet adapters. It has specific support for configuring the National Semiconductor AT/LANTIC DP83905 used in on ISA Ethernet adapters such as the NE2000plus. It also works several work-alike chips from other vendors.

OPTIONS

These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.
-h, --help
Show summary of options.
-V, --version
Show version of program.
-v, --verbose
Verbose mode.
-q, --quiet
Be very unverbose.
-a, --all
Print all registers.
-N, --NE2000
Set card to NE2000 mode.
-W, --wd8013
Set card to WD8013 mode.
-p, --base-address <port>
Specify port to use. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300).
-P, --new_ioport <port>
Set card to use new port. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300).
-F, --interface <interface>
Interface number. Valid Options are: 10baseT, 10base2, 10base5, AUI.
-Q, -i, --irq <irq>
Specify new interrupt. Valid values are: 3-5,9-12,15.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values.

SEE ALSO

mii-diag(8)

AUTHOR

This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).