Langue: en

Version: 2010-07-21 (fedora - 01/12/10)

Section: 8 (Commandes administrateur)


rmcpping - send RMCP Ping to network hosts


rmcpping [OPTION...] destination


rmcpping uses the RMCP Ping request datagram to elicit an RMCP Pong response from a remote host. The utility can be used to verify if a remote host supports RMCP or IPMI. The initial starting sequence number will be randomized.

rmcpping will return 0 to the environment if it receives atleast 1 response from the remote host. Otherwise, it exits with a value of 1.


The following options are available
Output help menu.
Output version.
-c count
Stop after sending count packets.
-i interval
Wait interval seconds between sending each packet. The default is to wait for one second between each packet.
-I interface address
Set source address to specified interface address. Argument may be numeric IP address or name of device.
-t timeout
Time to wait for a response, in seconds. Default is five seconds.
Verbose output.
-s num
Specify an initial starting sequence number. The default is to use a random initial sequence number.
Turn on debugging.


It has been observed that some remote BMCs can get "confused" and delay packet responses if duplicate packets (with duplicate sequence numbers) are sent in succession very quickly. There is no known way to cleanly deal with a "confused" BMC other than the wait awhile.

Unlike ping(8), local network devicess (e.g. cannot be "pinged".


Report bugs to <freeipmi-users@gnu.org> or <freeipmi-devel@gnu.org>. Copyright (C) 2007-2010 Lawrence Livermore National Security, LLC.
Copyright (C) 2003-2007 The Regents of the University of California.

This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 2 of the License, or (at your option) any later version.


Command and manpage based off ping(8).


freeipmi(7), ping(8), ipmiping(8)